 |
| By Cheryl Ball for ilovetoCreate |
Wrap that special gift in packaging that’s just as fabulous! Stitch felt into a candy-colored tote then add wintery accents with Tulip® 3D Fashion Paint™ for a gift bag that looks so good, no one will care about what’s inside!
Materials List
- Tulip® 3D Fashion Paint™
65000 White 65109 Pink -
Miscellaneous
- Tracing paper
- (1) Button –1” white
- Permanent felt pen
- White chalk – sharpened to a point
- Foil
- Sewing machine with matching thread
- Embroidery floss – white
- Sewing pins
- Pencil
- Needle with large eye
- Scissors
- Self-adhesive shelf paper
- Paper towels
- Plastic knife
- Felt yardage – pink, red – ½ yard each
-
Patterns
Instructions
- Enlarge bag pattern to 14” from handle to base and 12” at widest part, then draw in hole for handle. Cut an oval base for bag that’s 8 ½” x 4 ½”.
- Pin tote and base pattern onto double layer of red felt then cut out. Repeat on a double layer of pink felt.
- Layer and pin together pink and red felt pieces with red facing outward. Sew a ¼” seam along top edge and around inside handle on both sections. Trim seams if necessary to even out.
- Pin sides together then sew along edges.
- Thread a needle with three strands of white embroidery floss then tie a knot in ends, creating six strands. Whip stitch around sides, inside handle and along top edge.
- Use pencil to trace triangle pattern design onto tracing paper, then trace five more, equally spacing to create snowflake as shown.
- Place shelf paper shiny side up over pattern then use felt pen to trace design onto shelf paper. To create stencil, carefully cut out inside of each section, leaving outside edges intact.
- Position stencil on tote, press to secure then run a finger along inside cut edges to prevent paint seepage.
- Squeeze a puddle of Pink Slick 3D Fashion Paint onto foil. Use knife to spread paint into each section of design, leaving an even coat. Carefully remove stencil and let dry.
- Trace other design onto tracing paper. Flip pattern over then use chalk to trace over lines. Position design between each painted section on bag then run a finger along lines, transferring design in chalk onto bag. Repeat steps, retracing design with more chalk as needed.
- Start flow of White Slick on paper towel, using an even pressure on bottle for a smooth line. Trace over design lines with White Slick. Add pink dots with a white dot in center where shown. Squeeze a dot of Pink Slick at center of snowflake design then press button into paint. Refer to photo. Let dry.
- Pin bottom sections in place then whip stitch along edges.
