I encourage you to dig into your fabric stash to find an unlikely contender for the fabric insert on this one. The fabric I used was originally purchased by my brother from a discount bin to use as a bed skirt. I inherited it when he moved, and my mom and I made curtains to filter the light in my apartment. Now the remnants have been reincarnated as part of this heat-beating T-shirt. What a life cycle! Tip: Check the give of your fabric--you shouldn't have to worry too much about working on the bias (the diagonal of the fabric) since the rest of the T-shirt will have plenty of stretch, but consider your layout before you cut!
Materials:
-regular fit T-shirt
-fabric scissors
-disappearing ink pen
-ruler
-straight pins (optional)
-Aleene's OK Wash-It fabric adhesive (or a sewing machine and thread to match your fabric)
Make it:
1. Turn the T-shirt inside out and lay it face down. Measure and mark about 3 1/2" to 4" in from either edge along the hem. Then draw a straight line from each mark to its adjacent sleeve (at the armpit).
2. Cut along that line through only the back layer. Continue cutting around the sleeve, just inside the seam (again, through only the back layer), along the top shoulder seam, and along the back of the neckband. Continue cutting until the back panel of the shirt can be removed. Set the front of the shirt aside momentarily.
3. Lining up the bottom edges of the fabric pieces, lay the back panel of the T-shirt over the backing fabric and trace the panel, extending the shape on either side to accommodate for the 3 1/2" to 4" wedge that was cut away. (The extra fabric will help create the flare.) Cut out the shape from the backing fabric.
4. Lay the fabric against the front piece of the T-shirt so that the edges of the two pieces line up, right sides together. Use the permanent fabric adhesive to glue the inside edges together. Optional: Use straight pins to hold the fabric edges in place before you glue.)
5. Ease the edges together, pinching and pressing them in place. Then let dry completely.
6. Turn the tee right side out and touch up any gaps along the seams.
7. Layer the tee over a thin tank top if you're feeling demure, or be bold by wearing a colorful, barely there undergarment (the point is to limit the layers of fabric on the skin after all!).
Variations:
-Replace a panel along the top of the sleeve as well.
-Replace a smaller panel in the back of the T-shirt with a cotton crocheted doily.
-Make the flare more exaggerated and fluttery.
-Experiment with different fabrics (silk scarf, old mesh sports jersey, a linen table cloth).
Next up? Though I quite like the subtle contrast in whites (the stark cream with the more ivory gauze), I'm going to experiment with dye the next time I make this design!
